Description: Slip-IT is an anti-sticking silicone spray that is packaged in a convenient, ready-to-use aerosol can. It forms a protective silicone shield over the surface of anything upon which it is applied. Slip-IT prevents ink, water, gum, liquids, powders, and glues from adhering to any surface. Directions: Shake well, Remove cover and hold can upright when in use. Shield areas not to be sprayed. Spray Slip-IT, holding can 10-12 inches from surface. Spray evenly on to cleaned area. Spread Slip-IT with a cloth if too much has been applied. Product Need and Usage: Lithography: Use in any application requiring slip and antifriction enhancement, or repelling of ink or water. Use on any press surfaces to prevent ink from sticking. Spray into ink fountain before filling with ink to simplify cleaning and shorten wash-up time. Spray on impression cylinder to prevent pick-up of ink. Apply periodically to blanket cylinder and plate cylinder to stop rust and corrosion. It also prevents sticking of packing sheets. Spray onto surfaces of feeder and delivery wheels where ink builds up. Flexography/Corrugated Boxes: Spray into relief areas of rubber dies before inking to prevent excessive build-up of ink, paper and dust. Features:
Technical Specifications:
Disclaimer: Unless otherwise restricted by applicable law, nothing contained in this literature shall be deemed a representation or warranty of any kind, either expressed or implied. See the Material Safety Data Sheets (MSDS) for this product for safety information prior to use. |
| ||
| Slip-It - Silicone spray 1 Spray Can $10.95 | |
|